Ground your other amps as the SAME spot on chassis. Drill a hole for each ground so that you don't have to stack connections. But, yes, keep them all grouped together about an inch apart. Place the cap in parallel with the subs amp, directly before it, but grounds are separate as talked about above. The distro should be placed before the cap, and its job is to separate sub wire and mains wire.

How Capacitors Work



The Most Popular Jazz Guitar Amps (Top 25) - Survey Results
Can 2 capacitors be used as one? Oct 18, 1. Feb 26, Cleveland, OH. The experts will know this right away, so here goes


All Categories
If you are merely powering a low end set of 6x9's as additional speakers, it won't pull much more than a couple of amps. Like Tweet. Roch Pottier. Mike Manning.



Multiple electronic amplifiers can be connected such that they drive a single floating load bridge or a single common load parallel , to increase the amount of power available in different situations. This is commonly encountered in audio applications. Bridged or paralleled modes of working, normally involving audio power amplifiers, are methods of combining the output of two identical amplifiers to provide, what is in effect, a mono amplifier. Combining more than two amplifiers can be effected using the basic principles described, including the possibility of bridge and parallel modes in combination. Two identical amplifiers are most often encountered in a common case, with a common power supply, and would normally be regarded as a stereo amplifier.